date revision 55PC0241 specifica tion control dra wing title upper spec limit target value target value diameter ( in.) weight ( lbs/1000 ft. ) lower spec limit 2422 20 18 16 14 12 10 conductor size (awg) upper spec limit .087.100 .119 .139 .155 .189 .231 .283 .102.117 .139 .163 .182 .221 .270 .331 .117.134 .159 .188 .209 .253 .309 .379 8.06 11.8017.83 26.83 34.07 52.44 80.33 126.67 8.38 12.1918.32 27.56 34.92 53.64 81.99 129.46 cable ratings and additional requirements 10-22-05 b this specification sheet forms a part of the latest issue of raychem specifiction 55pc. component wires - 55pc0211 construction details part number 1 / 55PC0241-24-*55PC0241-22-* 55PC0241-20-* 55PC0241-18-* 55PC0241-16-* 55PC0241-14-* 55PC0241-12-* 55PC0241-10-* part number: the "*" in the part numbers above shall be replaced bya color code designator with a slash separating the component wire colors. colors shown do not necessarily reflect the sequence of manufacturing. 1 / example: awg 22, black, red, orange and yellow component wires: 55PC0241-22-0/2/3/4 temperature rating: 150c maximum continuous conductor temperature voltage rating: 600 volts (rms) at sea levelinsulation flaws: impulse dielectric test, 8.0 kv (peak) four conductor cable, unshielded, unjacketed, 600 volt ? 2005 tyco electronics corporation. all rights reserved. tyco electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to buyer. r wire & cable 501 oakside avenueredwood city, ca 94063-3800 phone: 1-800-227-8816 fax: 1-650-361-6297 page 1 of 1 this specification sheet takes precedence over documents referenced herein. referenced documents shall be of the issue in effect on date of invitation for bid. dimensions are in inches and, unless otherwise designated, are nominal 1 / colors and color code designators shall be in accordance with mil-std-681. however, due to length limitations of the raychem part number, an alternative color code may replace mil-std-681 color code designators. (example: 901/902... may be replaced by axxx.) other codes and suffixes may be added to the part number, as necessary, to capture any additional requirements imposed by the purchase order. users should evaluate the suitability of this product for their application. specifications are subject to change without notice.
|
